41 00... Procedure For Vehicles With Active Pedestrian Protection (AFGS) After An Accident

2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 41 00... Procedure For Vehicles With Active Pedestrian Protection (AFGS) After An Accident
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

The AFGS system consists of the following components:

  • Satellites (control unit + sensor) 
    • Sensors, inside, bumper trim, left/middle/right
    • ACSM control unit (Crash Safety Module)
  • Cables and connectors 
  • Engine compartment lid hinges 
    • Actuator
    • Engine compartment lid hinge
  • Engine compartment lid catch 
    • Catch, engine compartment lid
    • Catch, upper section (striker)

In case of a frontal or side collision in the area of the engine compartment lid and/or the A-pillars, check the following components:

Satellites (control unit + sensor) 

  • Procedure
    • Read fault memory
    • Disconnect battery and observe waiting period
    • Rectify faults
    • Reconnect battery and observe waiting period
    • Delete fault memory
    • Switch off ignition and wait at least 2 minutes (no consumers may be switched on during this period such as interior light, radio, etc.)
    • Switch on ignition.
    • Clear fault memory and if necessary rectify faults

Cables and connectors 

  • Procedure
    • Check cables and connectors for damage, replace if necessary.

Procedure if AFGS was activated: 

Engine compartment lid hinges 

Engine compartment lid catch 

Procedure if AFGS was not activated: 

Engine compartment lid hinges 

Engine compartment lid catch 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.