SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2339 (PAINTWORK - REPAIR)PAINTWORK99 00... MISCELLANEOUS PAINTING
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans

99 00... Miscellaneous painting

2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 99 00... Miscellaneous painting
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Follow GENERAL INSTRUCTIONS ON PAINTING .

The graphics are schematic representations and are to be applied to the relevant vehicle type.

Engine compartment, complete 

Carry over the area shown symmetrically to the other side of the car.

Fig 1: Identifying Engine Compartment Area
G06897783Courtesy of BMW OF NORTH AMERICA, INC.

Engine bulkhead 

Fig 2: Identifying Engine Bulkhead Area
G06897784Courtesy of BMW OF NORTH AMERICA, INC.

Engine support (partial replacement before spring strut dome) 

Inner side shown

Fig 3: Identifying Engine Support (Inner Side)
G06897785Courtesy of BMW OF NORTH AMERICA, INC.

Engine support (partial replacement before spring strut dome) 

Outer side shown

Fig 4: Identifying Engine Support (Outer Side)
G06897786Courtesy of BMW OF NORTH AMERICA, INC.

Engine support (inside only) 

Fig 5: Identifying Engine Support (Inside)
G06897787Courtesy of BMW OF NORTH AMERICA, INC.

Wheel arch, front, complete 

Inner side shown

Fig 6: Identifying Wheel Arch (Inner Side)
G06897788Courtesy of BMW OF NORTH AMERICA, INC.

Wheel arch, front, complete 

Outer side shown

Fig 7: Identifying Wheel Arch (Outer Side)
G06897789Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment floor 

Carry over the area shown symmetrically to the other side of the car.

Fig 8: Identifying Luggage Compartment Floor Area
G06897790Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.