Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
51 11... Removing and installing/replacing holder for side view camera on left or right
Necessary preliminary tasks:
- Remove SIDE VIEW VIDEO CAMERA
- Pull side view video camera holder off bumper with a suitable tool (holder is secured with double-sided adhesive tape).
Installation:
Holder (1) is encoded against incorrect installation.
Identification (2) indicates on which side of the vehicle holder (1) is stuck in.
For installation position observe shape of holder (1).
Installation:
Clean bonding surface on bumper trim (4) and remove adhesive residues.
To position holder (1) optimally, pre-install camera (3) on holder (1) before sticking in the holder.
Outer edge (2) on holder (1) must be flush with outer bumper edge (4).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.