Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2056 (COLLISION - BODY PANEL REPAIR (F01, F02))BODY REPAIR GENERAL INFORMATION41 00... BONDING ON PAINTED SURFACESNOTES
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
41 00... Bonding On Painted Surfaces: Notes
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION Notes
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
These repair instructions apply only to components of the outer skin and not to structural components.
These include roof outer skin, tail panel, rear side panels and components of the luggage compartment floor.
Follow the vehicle-specific repair instructions.
Only use the repair procedures described there.
Conform with safety precautions! See SAFETY AT WORK and INFORMATION ON HAZARDS .
These include roof outer skin, tail panel, rear side panels and components of the luggage compartment floor.
Follow the vehicle-specific repair instructions.
Only use the repair procedures described there.
Conform with safety precautions! See SAFETY AT WORK and INFORMATION ON HAZARDS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.