SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2018 (FRONT AXLE - REPAIR)GENERAL31 00 MOBILE TABLE LIFT
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans

31 00 Mobile table lift

2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 31 00 Mobile table lift
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Danger of injury!

Before beginning work, position table lift with the lower frame securely on the floor.

Danger area around mechanism below platform.

  • Do not reach into or step into the danger area.
  • Note permissible bearing capacity of table lift.
  • Mount load centrally (danger of tipping) and secure against shifting.

Follow the operating instructions from the equipment manufacturer.

The mobile table lift is used for collision repairs and when removing large engines.

Adaptations for mounting front axle with engine and transmission.

No. 10 For mounting swivel bearing with brake disc
No. 20 Retaining element for adjustable fixture
No. 30 Adjustable fixture
No. 40 Distance pin 40 x 160 mm
No. 50 Distance pin 40 x 110 mm
No. 60 Distance pin 40 x 60 mm
No. 70 Fixture with U-profile
No. 80 Plate fixture Ø=100 mm
Fig 1: Identifying Mobile Table Lift Components
G08504566Courtesy of BMW OF NORTH AMERICA, INC.

Release star knob screw on working plate (B) of table lift; the working surface (B) can be extended by approx. 310 mm.

Release all push-pull clamps and the working plates can be shifted by approx. 20 mm.

Working plate (A and B) can be raised and lowered by 3° on the long side and by 5° on the transverse side.

Working plate (A and B) is subdivided by a coordinate system and a possible installation position is recommended in the respective repair manual.

Fig 2: View Of Work Plate Coordinate System
G08504567Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.