Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
41 00... Stamping Vehicle Identification Number
Special tools required:
Read and comply with GENERAL INFORMATION .
Necessary preliminary tasks:
- Remove FRONT RIGHT SPRING STRUT .
Special tool kit 41 1 190 for stamping vehicle identification number consists of:
Guide plate 41 1 191
Counter-plate 41 1 192
Position counter-plate 41 1 192 at bottom on spring strut dome.
Position guide plate 41 1 191 at top on spring strut dome and tighten down screws (1).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.