Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
13 62 592 Removing and installing/replacing pressure sensor on right intercooler (S63)
Necessary preliminary tasks
- Read out fault memory of DME control unit.
- Turn off ignition.
- Remove INTAKE FILTER HOUSING .
Unclip Bowden cable for engine bonnet/hood actuator from transverse reinforcement (1).
Release screws on left and right.
Tightening torque 51 71 4AZ .
Remove cross-brace (1).
Installation:
Reinstall left and right holder for vacuum filter housing.
Unlock plug (1) and remove.
Unfasten screws (2).
Tightening torque 13 62 7AZ .
Pull pressure sensor (3) out of right intercooler.
Installation:
Replace sealing ring on pressure sensor.
Installation:
Delete fault memory.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.