Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 115 Removing and installing/replacing footwell module
Necessary preliminary tasks
- Clamp off BATTERY NEGATIVE LEAD .
- Only disconnect E72: both battery earth cables.
- Remove FOOTWELL SIDE TRIM PANEL ON A-PILLAR, LEFT .
Fold back carpet (1) in area of A-pillar a little.
Disconnect plug connection (2).
Release plastic nuts (3).
Pull footwell module (4) forwards a little.
Disconnect plug connection (5).
Replacement
Carry out PROGRAMMING/ENCODING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.