84 11 530 Removing and installing/replacing interface for D-Network car phone

2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 84 11 530 Removing and installing/replacing interface for D-Network car phone
WARNING: This page is about a different car, the 2003 BMW Z8, 2002 BMW Z8, 2001 BMW Z8, and 2000 BMW Z8. However, it is still accessible from the selected car via links, so may be relevant.

Remove center console. Refer to 51 16 200 REMOVING AND INSTALLING CENTER CONSOLE .

Release screws (1) and remove interface (2) in direction of arrow.

Fig 1: Removing Interface
G03207560Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections.

Fig 2: Removing Holder And Interface
G03207561Courtesy of BMW OF NORTH AMERICA, INC.

Turn holder and remove.

Remove interface.

Replacement:Β 

Detach interface (1) from holder (2).

Fig 3: Detaching Interface From Holder
G03207562Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.