Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1867 (BODY EQUIPMENT - REPAIR)SAFETY AND GENERAL INFORMATION51 00... NOTES ON INSTALLATION OF RUBBER WINDOW SEALS2. GENERAL NOTES
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
2. General notes
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 2. General notes
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Use only the BMW-approved anti-friction agent for fitting
- Application only at room and object temperatures between 18 and 25 °C
- Lubricant dries at different rates depending on the quantity, temperature and ventilation and becomes sticky
- Lubricant can only be used for fitting and not for fault elimination (e.g. grating)
- Newly painted parts may only be brought into contact with the anti-friction agent after cooling
- Optimal bonding/attachment to the background surface is achieved after approx. 48 hours. The window guide seal must not be exposed to mechanical strain beforehand (car wash, strength test, etc.).
IMPORTANT:
To avoid unwanted noises, do not use soapy water (low-surface-tension water with washing-up liquid) or lubricant containing silicone
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.