SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1867 (BODY EQUIPMENT - REPAIR)MUCKET FOR DOORS51 72... SEALING INSTALLATION
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans

51 72... Sealing installation

2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 51 72... Sealing installation
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The utmost care must be taken when removing all sealings on the vehicle. Incorrect fitting can lead to wind noise and water ingress among other things and can affect the ease of closing and opening.
  • In general, the following applies: 

    Sealings on the side frame can be fitted and removed any number of times.

  • Sealings must not be damaged or torn.
  • The clamping area must be compressed by hand far enough to ensure that a tight connection on the side flange is still possible. The sealing shanks may touch each other slightly. A completely compressed sealing is not permitted.
    Fig 1: Identifying Fitting Seals Correct Position
    G06176813Courtesy of BMW OF NORTH AMERICA, INC.
  • It is not necessary to use special tools for compressing the clamping area. This can be done carefully by hand.
  • The sealings must always be fitted except in the case of blockages. There is no defined contact pressure.
  • A new gasket must be fitted if sealings in the tailgate area are repeatedly fitted and removed (water ingress due to cracked sheet metal).
    Fig 2: Identifying Fitting Seals Improper Position
    G06176814Courtesy of BMW OF NORTH AMERICA, INC.
  • Sealings must be checked for correct positioning after fitting. If necessary, sealings should be lifted over the adjacent components using the appropriate tool. Neighboring components must not be damaged.
  • Sealings must be replaced if the metal inlay of the sealing is visible (corrosion).
  • Ensure that the clamping area is smooth.
    Fig 3: Identifying Clamping Area
    G06176815Courtesy of BMW OF NORTH AMERICA, INC.
  • Sealings that are installed with plastic clips fit tightly against the body. If this is not the case, replace the clips or sealings.
    Fig 4: Identifying Joint Seal And Plastic Clips
    G06176816Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.