Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1724 (GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS)GENERAL ELECTRICAL SYSTEM61-0309 RELEASE TOOL
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
61-0309 Release tool
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 61-0309 Release tool
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
0495391 610309 Release tool MP
NOTE:
(Release tool for pin-end round contact (D=1.5) manufactured by Kostal) Replaces from 09/2005 special tool 61 1 139 [released]
Storage Location
M22 x 205
SI number
02 05 05 (217)
Consisting of:
- 10 = 0495393 Holding sleeveNOTE: (Replacement sleeve for special tool 61 0 309) Replaces from 09/2005 special tool 61 1 154 [released]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.