Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1599 (FRONT AXLE - SPECIAL TOOLS - E91)
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
Section 1599 (Front Axle - Special Tools - E91)
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION Section 1599 (Front Axle - Special Tools - E91)
WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
- 31 Front Axle
- 31-4080 Adapter
- 31-5090 Adapter
- 31-5120 Bush
- 31-2100 Device
- 31-2110 Device
- 31-5070 Device
- 31-2160 Device
- 31-5250 Fixture
- 31-5220 Fixture
- 31-4060 Fixture
- 31-5000 Fixture
- 31-4050 Fixture
- 31-5110 Fork
- 31-3350 Holder
- 31-3358 Insert ring
- 31-5030 Mandrel
- 31-5130 Mandrel
- 31-5020 Mandrel
- 31-1140 Open-end spanner
- 31-5060 Pin
- 31-5200 Pliers
- 31-2310 Pressing-out tool
- 31-2300 Pressing-out tool
- 31-2230 Socket
- 31-3340 Spring tensioner
- 31-2220 Support
- 31-5050 Thrust piece
- 31-3030 Tool
- 31-2240 Tool
- 31-5040 Washer
- 31-5100 Washer
- 31-5080 Washer
- 31-2210 Wrench socket
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.