Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 154 (ELECTRICAL COMPONENT LOCATOR)SWITCHES
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
Section 154 (Electrical Component Locator): Switches
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION Switches
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 1998 BMW 750iL, 1998 BMW 740iL, 1998 BMW 740i, 1997 BMW 750iL, and 1997 BMW 740iL. However, it is still accessible from the selected car via links, so may be relevant.
SWITCHES LOCATION
| Component | Location |
|---|---|
| Brake Fluid Level Switch (B18) | Left rear of engine compartment. See Figure. |
| Brake Light Switch (S29) | Left side of dash. See Figure. |
| Dual Temperature Switch (S36) | Right front of engine compartment. See Figure. |
| Engine Coolant Level Switch (S63) | Right front of engine compartment. See Figure. |
| High Pressure Switch (B8) | Right front of engine compartment. See Figure. |
| Oil Pressure Switch | Under Oil Filter. See Figure. |
| Park Brake Switch (S31) | Left side of dash. See Figure. |
| Underhood Light Switch (S19) | Right front of engine compartment. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.