Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1312 (GENERAL ELECTRICAL SYSTEM - REPAIR - F01/F02)CONTROL UNITS, MODULES61 35... VEHICLE PROGRAMMING AND CODING
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
61 35... Vehicle programming and coding
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 61 35... Vehicle programming and coding
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- In order to avoid incorrect programming procedures and error messages, it is essential when working with the ISTA/P programming system always to use the version.
- Battery voltage must not drop below 13.0 V
during programming. Connect battery charger prior to programming
Use only BMW-recommended battery chargers
Programming sequence via ISTA/P:
- Identify vehicle and read out control unit data
- Draw up and configure measures plan
- Prepare programming, export CBS/CKM data
- Carry out repair measures, replace control units if necessary
- Identify vehicle again after repair. Update measures plan
- Carry out programming
- Assess programming afterwards, import CBS/CKM data
- Programming successfully completed
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.