Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Preparation for installation
Prepare plastic nozzle(s) for shaping adhesive bead (when not using the standard nozzle C), can be cut to size during the air drying time.
Lay a sample bead of approx. 50 mm; if OK, apply immediately to window glass.
- Interruption must be < 5 seconds (incorrect mixture ratio).
Glue cartridge must be vertical to window glass.
Black ceramic glass impermeable to UV light is located on the peripheral zone of the inside edge of the window to protect the adhesive bead.
Ceramic glass must not be damaged and must be treated as follows.
Treatment of ceramic glass surface (inside of window):
| Adhesive (with part numbers) | Treatment |
|---|---|
Repair kit:
|
|
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.