Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 31 037 Removing and installing/replacing light control unit: Notes
Necessary preliminary tasks:
- Remove left fresh-air grille . See 64 22 135 REMOVING AND INSTALLING OR REPLACING LEFT FRESH-AIR GRILLE .
Press out light control unit (1) from inside.
Disconnect plug connection (1).
Remove light control unit.
Installation:
Make sure retainers (2) are correctly seated on trim of light control unit.
If necessary, replace faulty retainers.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.