Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
51 33 000 Removing And Installing (Replacing) Power Window Unit In Left Or Right Front Door: Notes
Risk of injury!
Carry out work on the power window unit only when the power window motor is de-energized.
Necessary preliminary tasks:
- Remove front door window glass
Peel back film (1) and loosen nuts below.
Release nuts (2) and feed out rear section of power window unit (3).
Tightening torque, see 51 33 1AZ in 51 33 POWER WINDOWS, FRONT .
Installation:
Replace defective film (1) if necessary.
Loosen window regulator (3) at bracket (1).
Release nuts (2) and completely feed out power window unit (3).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.