Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
72 11 101 Removing And Installing/Replacing Rear Center Seat Belt (Buckle And Anchor)
Necessary preliminary tasks:
- Partially remove BACKREST COVER .
Release screw (1).
Tightening torque: 72 11 26AZ .
Remove end fitting.
Installation:
End fitting is coded against incorrect assembly.
Unclip retainers (1) for belt pin on left and right.
Remove belt pin (2).
Unscrew nut (3).
Tightening torque: 72 11 25AZ .
Remove retractor mechanism.
Installation:
Retractor mechanism is coded against incorrect assembly.
Feed anchor fitting out of backrest cover and backrest frame.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.