Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 00... Safety instructions for handling vehicle battery
Do not allow any battery acid to come into contact with the eyes, the skin or clothing. Therefore wear protective clothing, gloves and eye protection.
Do not tilt the battery, acid may emerge from the vent hole.
If acid is splashed into the eyes, rinse them immediately for several minutes with clear water. You must then consult a doctor without delay.
If acid is splashed onto the skin or clothing, neutralize it immediately with a soap solution and rinse with lots of water.
Seek medical attention immediately if battery acid is accidentally swallowed.
Strictly no flames, sparks, naked light or smoking!
A highly explosive detonating gas is created when batteries are charged. The rooms where charging is carried out must therefore always be well ventilated.
Avoid the formation of sparks when handling cables, wiring and electrical devices.
Turn the ignition lock to the 0 position before disconnecting or connecting the battery.
Do not place tools or any similar object on the battery (danger of short circuit and explosion hazard!).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.