Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 31 043 Removing and installing/replacing roof switch cluster
2011 BMW Z4 35isSECTION 61 31 043 Removing and installing/replacing roof switch cluster
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .
Carefully lever out roof switch center (1) with special tool 00 9 317 and lower slightly.
Unlock retaining clips (1) and feed out roof switch center in direction of arrow.
Disconnect plug connections (1) and remove roof switch center.
IMPORTANT:
Disconnecting the plug connection for the hands-free microphone or emergency SOS call button results in fault memory entries in the telephone control unit (limitation in the emergency SOS call system).
After fitting, read out fault memory and if necessary delete entries.
After fitting, read out fault memory and if necessary delete entries.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.