Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 61 081 Replacing (removing and installing) left or right windscreen wiper arm
Special tools required:
Remove cover cap for wiper arm (1) on left or right.
Release nut underneath. Tightening torque 61 61 11AZ .
Detach wiper arm (1) with special tool 61 6 060 .
Installation:
Adjust position of wiper arm in question in rest position (measured between wiper lip and top edge of cowl panel cover).
Then tighten down wiper arm and check ADJUSTMENT DIMENSIONS of relevant wiper arm again.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.