Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
86 10... Replacing drawbar members, left and right: Notes
2011 BMW X6 50iSECTION Notes
NOTE:
Disassembly of overrunning equipment,
refer to Removing overrunning equipment/maintaining or replacing guide bush/installing overrunning equipment .
Remove complete brake pull rod.
Removal of position light cable,
refer to 86 10... REPLACING LICENSE PLATE LIGHT .
refer to Removing overrunning equipment/maintaining or replacing guide bush/installing overrunning equipment .
Remove complete brake pull rod.
Removal of position light cable,
refer to 86 10... REPLACING LICENSE PLATE LIGHT .
Release screws (1) on cross-member (2). Pull out crossmember (2) towards rear.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.