Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011X5 50IREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 178 (OPERATING FLUIDS - ENGINE)
2011 BMW X5 50i
Section 178 (Operating Fluids - Engine)
2011 BMW X5 50iSECTION Section 178 (Operating Fluids - Engine)
WARNING: This page does not describe the selected car, but rather 250 other vehicles, including the 2006 BMW Z4, 2006 BMW X5, 2006 BMW X3, 2006 BMW M6, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- 1.0 General Information
- Notes
- Good Wear Protection and Friction Reduction
- Limited Tendency to Produce Combustion Residue
- Favorable Viscosity Temperature Behavior
- Anti-Foaming
- Good Corrosion Inhibition
- Mixing Ability/Compatibility
- Good Thermal Conductivity/Good Cooling Property
- Good Dispersant/Detergent Qualities
- Oxidation Inhibitors and Aging Stability
- 2.0 Grading Of Oils
- 3.0 Engine Oil Requirements and Specifications
- 4.0 Engine Oil Change Intervals
- 5.0 Condition Based Service
- 6.0 Engine Oil Additives
- 7.0 Break-In Instructions
- 8.0 Engine Oil Applied to Engine Exhaust Studs
- 9.0 Lubricant For Oxygen Sensor
- 10.0 Oil Consumption
- 11.0 References
- 12.0 Operating Fluids Table and Alternate Suppliers
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.