Distributed function of the power window regulators

2011 BMW X5 50iSECTION Distributed function of the power window regulators

The power window regulator function is implemented by a number of control modules. The footwell module actuates the front power windows. The rear power windows, if fitted, are activated through the junction box electronics.

Fig 1: Power Window Regulators - Circuit Diagram
G09912069Courtesy of BMW OF NORTH AMERICA, INC.

The graphic shows the E70

Index Description
1 Power-window motor, driver's side at front
2 Footwell module (FRM)
3 Power windows motor, passenger's side at front
4 Power windows switch, passenger's side at front
5 Car Access System (CAS)
6 Hall sensor for power window, passenger's side at rear
7 Power windows motor, passenger's side at rear
8 Rear passenger's side power windows switch
9 Junction box with junction box electronics (JBE)
10 Rear driver's side power windows switch
11 Power windows motor, driver's side at rear
12 Hall sensor for power window, driver's side at rear
13 Switch block, driver's door

The control modules involved communicate via the data buses in the vehicle. The junction box supplies the control modules with voltage.

No liability can be accepted for printing or other faults. Subject to changes of a technical nature

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.