Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Functional Description - Charging, Cooling, Fuel Supply, HVAC, Lubrication, Steering Systems
2011 BMW X5 35iSECTION Functional Description - Charging, Cooling, Fuel Supply, HVAC, Lubrication, Steering Systems
- Charging System - Functional Description
- Alternator
- Alternator oscilloscope display
- Energy diagnosis: General
- Energy diagnosis: Terminal 30g-f (bistable relay)
- Energy diagnosis: Terminal control
- Energy diagnosis: Unfavorable customer usage
- Intelligent battery sensor (IBS) and battery
- MSA and power management
- MSA test module 'zero gear sensor'
- MSA test module for brake partial vacuum sensor (BUS)
- Power management: Reduction or shutdown of individual electrical consumer
- Power supply, vehicle system
- Regular sleeping
- Cooling System - Functional Description
- Fuel Supply System - Functional Description
- HVAC System - Functional Description
- Center console control panel
- Evaporator temperature sensor
- Evaporator temperature sensor - attaching foam strips
- Independent/auxiliary heating malfunction or smoking
- Leak at the fresh-air duct
- Note on installing the blower
- Rear automatic heater/air conditioner FKA
- Rear blower stratification flap
- Lubrication System - Functional Description
- Steering System - Functional Description
- Active steering (AFS)
- Check control message: Active steering faulty, information memory
- Hydraulic line on the power steering cooler
- Leakage at hydraulic pump
- Electrical steering column calibration
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.