54 62 Roll-over protection system

2011 BMW M3 2D Coupe, StandardSECTION 54 62 Roll-over protection system
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 BMW 435i xDrive, 2016 BMW 435i, 2016 BMW 428i xDrive, 2016 BMW 428i, and 2015 BMW 435i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - ROLL-OVER PROTECTION SYSTEM

  Type Thread Tightening specifications Dimension
1AZ Rollover protection system to body F23/F33/F83 M10x95 Replace screws
Jointing torque 50 Nm
Angle of rotation 180 ±20 °
F23 M12x1.5x115 Replace screws
Jointing torque 68 Nm
Angle of rotation 120 ±15 °
F33/F83 M12x1.5x115 Replace screws
Jointing torque 96 Nm
Angle of rotation 120 ±15 °
2AZ Holder, ornamental grille to rollover protection system F33/F83 M6x16   8 Nm
3AZ Lock, wind deflector to rollover protection system F33/F83     4 Nm
4AZ Striker to rollover protection system F33/F83     9 Nm
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.