51 00... Notes On Fitting Window Guide Seals

1. Work safety when handling anti-friction agent G13*: 

• Wear protective goggles, protective gloves and if necessary an apron.
• Do not eat, drink or smoke in the area of processing/application
• Ensure rooms are well ventilated.
• Keep heat and ignition sources well away
• In event of skin contact: Wash areas of skin affected with soap and water immediately, change work clothing which has been fouled with anti-friction agent immediately (keep spare work clothing in reserve)
• In event of eye contact: Rinse eyes immediately with plenty of water and seek medical advice
• Observe safety data sheet

2. General notes: 

• Use only the BMW-approved anti-friction agent for fitting
• Application only at room and object temperatures between 18 and 25 °C
• Anti-friction agent dries at different rates depending on the quantity, temperature and ventilation and becomes sticky
• Anti-friction agent can only be used for fitting and not for fault elimination (e.g. grating)
• Newly painted parts may only be brought into contact with the anti-friction agent after cooling
• Optimal bonding/attachment to the background surface is achieved after approx. 48 hours. The window guide seal must not be exposed to mechanical strain beforehand (car wash, strength test, etc.).

3. Auxiliary materials and tools: 

• Spirit, cleaning cloth, plastic squeegee, needle
• Anti-friction agent G13* (manufactured by Zestron) part no. 83 23 0441 032 (*sourcing reference: BMW Parts Service)

4. Preparations: 

• Heat and remove anti-friction agent residues with a hot air blower or clean new part thoroughly
• Immediately prior to fitting, clean the work area with spirit in order to remove silicone and grease residues

5. Assembly: 

• Apply a thin coating of anti-friction agent to the reverse side of the window guide seal only
• Perform fitting within 30 minutes of applying anti-friction agent
• Anti-friction agent dries after fitting and becomes sticky