SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011M3 2D COUPE, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 591 (CODING AND PROGRAMMING - OVERVIEW - ALL MODELS)CODING & PROGRAMMINGDME CONTROL MODULE PROGRAMMINGPROGRAMMING PROCEDURES FOR "CUSTOMER SERVICE MEASURES"PROGRAMMING PROCEDURES FOR "EXCHANGE CONTROL UNIT"
2011 BMW M3 2D Coupe, Automatic DCT

Programming Procedures for "Exchange Control Unit"

2011 BMW M3 2D Coupe, Automatic DCTSECTION Programming Procedures for "Exchange Control Unit"
WARNING: This page does not describe the selected car, but rather 136 other vehicles, including the 2008 BMW 760Li, 2008 BMW 650i, 2007 BMW Z4, 2007 BMW X5, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Select this to program a replacement Basic DME control module.

Prior to any type of programming, make sure the DME fault memory is cleared and vehicle battery is connected to a BMW battery charger with stabalized 12.5V!

  1. 1. From the Programming selection menu select "2 Exchange Control unit"  and press continue.
    Fig 1: View Of Programming Procedures For Exchange Control Unit (1 Of 11)
    G03402972Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.