SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011M3 2D COUPE, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 557 (CODING AND PROGRAMMING - OVERVIEW)CODING, INDIVIDUALIZATION & PROGRAMMING (CIP)MANAGEMENTNOTES
2011 BMW M3 2D Coupe, Automatic DCT

Coding, Individualization & Programming (CIP): Management: Notes

2011 BMW M3 2D Coupe, Automatic DCTSECTION Notes
WARNING: This page does not describe the selected car, but rather 333 other vehicles, including the 2007 BMW Z4, 2007 BMW X5, 2007 BMW X3, 2007 BMW M6, and 2007 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

"Management"  can be selected from the main/initial CIP screen.

Fig 1: Selecting "Management" From Main/Initial CIP Screen (1 Of 2)
G03398026Courtesy of BMW OF NORTH AMERICA, INC.

Or

"Management"  can be selected from the Main CIP Selection screen.

Fig 2: Selecting "Management" From Main/Initial CIP Screen (2 Of 2)
G03398027Courtesy of BMW OF NORTH AMERICA, INC.

By selecting "Management" the following functions can be accessed:

  • Print previously performed Service Measure reports
  • Display the current version of CIP installed
  • Run a test on the software currently installed on the system (SSS)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.