Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
72 12 004 Removing and installing/replacing knee airbag module for driver protection
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE CABLE .
- REMOVE light operator unit.
Release screws (1).
Feed out trim panel for pedal mechanism (2) from marked area (3) and set down towards bottom.
Installation note:
Make sure trim panel is correctly fitted (marked area).
Release screws (1).
Release screw (1).
Release screw (1).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.