Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 20 503 Vehicle battery - closed-circuit current monitoring
Necessary preliminary tasks:
To access the ground cable of the battery, perform the necessary preliminary work described in the article DISCONNECTING BATTERY EARTH LEAD .
Do not disconnect negative lead of battery.
Connect diagnosis system.
Connect clip-on probe to negative lead of battery. The arrow on the current clamp must point towards the battery.
Measure closed-circuit current.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.