Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011M3 2D CONVERTIBLE, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 557 (CODING AND PROGRAMMING - OVERVIEW)PROGMANADMINISTRATIONSELF-TEST
2011 BMW M3 2D Convertible, Automatic DCT
Section 557 (Coding And Programming - Overview): Progman: Administration: Self-Test
2011 BMW M3 2D Convertible, Automatic DCTSECTION Self-Test
WARNING: This page does not describe the selected car, but rather 333 other vehicles, including the 2007 BMW Z4, 2007 BMW X5, 2007 BMW X3, 2007 BMW M6, and 2007 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Self-test can only be selected if the selected interface is not being used by another device (interface symbol has a green background).
Depending on the interface selected a test loop must be attached to the interface.
- For opps use test loop 663124 and 663131
- For OPS use test loop 663124
- For Diagnostic Head, no test loop is needed
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.