Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011ALPINA B7LREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 77 (DISTANCE SYSTEMS, CRUISE CONTROL - REPAIR)
2011 BMW Alpina B7L
Section 77 (Distance Systems, Cruise Control - Repair)
2011 BMW Alpina B7LSECTION Section 77 (Distance Systems, Cruise Control - Repair)
WARNING: This page is about a different variant/trim than selected.
- Park Distance Control
- 66 20 517 Removing and installing/replacing a front center left ultrasonic sensor (PDC)
- 66 20 519 Removing and installing/replacing a front, center right ultrasonic transducer (PDC)
- 66 20 521 Removing and installing/replacing a front center ultrasonic sensor
- 66 20 515 Removing and installing/replacing a front left ultrasonic transducer (PDC)
- 66 20 516 Removing and installing/replacing a front right ultrasonic sensor (PDC)
- 66 20 542 Removing and installing/replacing a rear ultrasonic transducer
- Adaptive Cruise Control
- 66 31 010 Adjusting remote sensor (LRR sensor) (2009-2010 only)
- 66 31 010 Adjusting ACC sensor
- 66 31 020 Removing and installing/replacing left or right short-range sensor (SRR sensor) (2009-2010 only)
- 66 31 016 Removing and installing/replacing long-range sensor (LRR sensor) (2009-2010 only)
- 66 31 006 Removing and installing (replacing) ACC sensor
- Lane Change Warning
- Parking Assist System
- Front Camera
- Reversing Camera
- 66 53 010 Calibrating reversing camera
- 66 53... Instructions for adapting adjustment unit for reversing camera (CORGHI KDS quick-action clamp)
- 66 53 180 Removing and installing (replacing) control unit for reversing camera
- 66 53 020 Removing and installing (replacing) reversing camera
- 66 53 060 Removing and installing/renewing the Top View camera
- 66 53 170 Removing and installing/replacing control unit for Top-/Rear-/Side-View Camera
- 51 11... Removing and installing/replacing holder for side view camera on left or right
- 66 53 030 Removing and installing/replacing side view camera on left or right
- Night Vision
- 66 54 001 Axially adjusting night vision camera
- 65 82 300 Removing and installing (replacing) Touchbox controller control unit
- 66 54 010 Removing and installing complete night vision camera
- 66 54 005 Removing and installing/replacing control unit for Night Vision System
- 66 54 015 Replacing lens cover for night vision camera
- 66 54 511 Replacing night vision camera
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.