Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 31 172 Removing and installing/replacing switch for electromechanical parking brake
2011 BMW 760LiSECTION 61 31 172 Removing and installing/replacing switch for electromechanical parking brake
Necessary preliminary tasks:
- DISCONNECT NEGATIVE BATTERY CABLE (to avoid fault memory entries)
- F03 Only: Disconnect both battery negative cables
- Remove GEAR SELECTOR SWITCH COVER
Release screws (1).
Remove switch for electromechanical parking brake (2) from cover for gear selector switch (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.