Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011750I BASE, 4.4 CREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMEMORY MODULESGENERAL ELECTRICAL SYSTEM - REPAIR - F01/F02CONTROL UNITS, MODULES61 35 245 REMOVING AND INSTALLING (REPLACING) SMART OPENER BOTTOM SENSOR LINE (NON-CONTACT REAR LID OPENING)
2011 BMW 750i Base, 4.4 C
61 35 245 Removing and installing (replacing) Smart Opener bottom sensor line (non-contact rear lid opening)
2011 BMW 750i Base, 4.4 CSECTION 61 35 245 Removing and installing (replacing) Smart Opener bottom sensor line (non-contact rear lid opening)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary work:
- Remove COVER ON REAR BUMPER PANEL .
Release latch mechanisms (1) and remove control unit (2) in direction of arrow.
Unlock associated plug connection (1) on control unit (2) and disconnect.
Feed out connecting line from cable clips (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.