Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 179 Removing and installing (replacing) rain/light/solar and condensation sensor (from 07/2012)
Necessary preliminary tasks:
- Remove INTERIOR REARVIEW MIRROR .
Removal:
Disconnect connector (1).
Unlock rain/light/solar and condensation sensor (2) at metal spring (3).
For this purpose, push against metal spring (3) on both sides and release lock (4) using a screwdriver.
After releasing lock, wait approx. 30 min. at 20°C for silicone surface to relax.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.