Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
66 20 517 Removing and installing/renewing a center front left ultrasonic sensor
Necessary preliminary work:
Release retaining tabs (2).
Press ultrasonic sensor from outside towards inside and remove.
Unfasten plug connection (2) and disconnect.
Installation note:
Retaining tabs (2) must not be damaged!
Make sure ultrasonic sensor is securely seated.
Before installation of ultrasonic sensor on wiring harness, clean plug connection!
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.