Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
32 43 010 Removing and installing/replacing control unit for active front steering: Notes
Necessary preliminary work:
- Disconnect BATTERY EARTH LEAD
- Release LEFT FRONT SEAT and tilt towards rear
- Remove front left DOOR SILL COVER STRIP
- Remove footwell SIDE TRIM PANEL on A-pillar
- Remove cover of BASS SPEAKER at left front
Fold back front left carpet to one side.
Unscrew nuts (1).
Tightening torque 32 43 1AZ .
Installation note:
Secure grounding strap (2) to screw fastening point.
Release screws (1).
Tightening torque 32 43 2AZ .
Disconnect plug connections (1) and remove control unit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.