Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
5.1. Crash Safety Module
The Crash Safety Module is contained in a housing with three sockets.
Two sockets serve to connect the wiring harness. One other socket is provided for the cockpit wiring harness.
The Crash Safety Module is located in the cockpit module behind the glove box, as it was not possible to locate it centrally on the transmission tunnel due to the size of the Crash Safety Module and the wiring harness connection. Only the associated sensor system has remained on the transmission tunnel, close to the center of gravity.
The Crash Safety Module does not contain any sensors. These have been relocated to an additional central sensor on the transmission tunnel.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.