Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011550I 4.4 C, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 420 (FUEL SUPPLY SYSTEM - SPECIAL TOOLS -- F33)
2011 BMW 550i 4.4 C, Automatic
Section 420 (Fuel Supply System - Special Tools -- F33)
2011 BMW 550i 4.4 C, AutomaticSECTION Section 420 (Fuel Supply System - Special Tools -- F33)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 BMW 435i xDrive, 2016 BMW 435i, 2016 BMW 428i xDrive, 2016 BMW 428i, and 2015 BMW 435i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel Supply
- 168010 Adapter Mechanical tool
- 161150 Device AM
- 161162 Fastener AM
- 161161 Fastener AM
- 2153909 Filling device Mechanical tool
- 161010 Fork Mechanical tool
- 161000 Fork AM
- 161156 Hook AM
- 2302783 Hose AM
- 161152 Hose AM
- 2355173 Hose AM
- 2353954 Leak detector MP
- 161151 Lid AM
- 168020 Lifting gear Mechanical tool
- 161190 Pin wrench Minimum set: Mechanical tools Mechanical tool
- 161030 Pin wrench Mechanical tool
- 161157 Plug AM
- 161154 Pressure reducer AM
- 2302782 Pump AM
- 2302919 Pump AM
- 2296522 Tester MP
- 161050 Tool Mechanical tool
- 161153 Valve AM
- 161155 Water separator AM
- 161040 Wrench Mechanical tool
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.