Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
13 62 560 Removing and installing/replacing left or right hot film air mass meter (N63)
Necessary preliminary work :
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove acoustic cover. See ACOUSTIC COVER (N63 B44 O 0/1) or ACOUSTIC COVER (N63) .
Picture shows the left side, the procedure for the right side is identical.
Release connector (1) and remove.
Unfasten screws (2).
Tightening torque 13 62 6AZ .
Pull hot film air mass meter (3) out of upper section of intake silencer housing.
Installation note:
Replace gasket on hot film air mass meter.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.