Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
66 53 170 Removing and installing/replacing control unit for Top-/Rear-/Side-View Camera
Necessary preliminary tasks
- Clamp off BATTERY NEGATIVE LEAD .
- Remove shoulder trim panel, left. See 51 47 ... REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT SHOULDER TRIM PANEL .
Remove lid of left luggage compartment trim panel (1).
Remove luggage compartment flap (2).
Unscrew nuts (1).
Lever out expanding rivet (2).
Remove left floor panel support (3).
Lever out expanding rivet (1).
Carefully raise wheel arch trim panel (2) a little on left of luggage compartment.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.