Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
12 41 020 Removing and installing/replacing starter (N63)
Necessary preliminary tasks:
- Switch off ignition.
- Disconnect BATTERY NEGATIVE LEAD .
- Remove right ENGINE SUPPORT ARM .
Unlock connector (1) and remove.
Slacken nut (2).
Tightening torque 12 42 2AZ .
Detach starter positive cable.
Release screws (1).
Tightening torque 12 41 1AZ .
Disengage cable (2) from holder.
Pull out starter in direction of travel, feed out and remove.
Installation note:
When replacing the starter, convert cable holder for cable (2).
Installation note:
Check starter pinion and starter ring gear for damage. If necessary, replace damaged components.
Reassemble the vehicle.
Only during starter replacement and on vehicles with MSA (automatic engine start-stop function):
- Use BMW diagnosis system to reset the starter counter.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.