Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
13 62 560 Removing and installing/replacing the hot film air mass meter (N55 Hybrid)
The following points must be strictly observed prior to starting work :
- Observe SAFETY INFORMATION for handling hybrid cars
Necessary preliminary tasks:
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove IGNITION COIL COVER .
Release clamps (1).
Tightening torque 13 71 3AZ .
Unlock connector (2) on hot film air mass meter and disconnect.
Disconnect clean air pipe (3) from rubber mount at top and remove.
Release screws (1).
Tightening torque 13 71 4AZ .
Pull hot-film air mass meter (2) out of upper section of clean air pipe.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.