Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 14... Removing and installing/replacing engine compartment B+ terminal
Necessary preliminary tasks
- Remove cover from electronics box . See 12 90... REMOVING AND INSTALLING/REPLACING ELECTRONICS BOX or 12 90... REMOVING AND INSTALLING/REPLACING ELECTRONICS BOX .
Unclip covers (1) and release nuts underneath.
Tightening torque: 61 12 4AZ .
Remove battery positive cables.
Unclip cover (1).
Unscrew nuts (1). Tightening torque: 61 12 4AZ .
Remove battery positive cables.
Release locks (2) and remove frame (3) towards rear from B+ terminal.
Unclip B+ terminal and remove towards front.
Installation:
Make sure frame (3) engages correctly in B+ terminal.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.