Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011335IS 2D COUPE, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2545 (DOUBLE CLUTCH GEARBOX - REPAIR - F12)
2011 BMW 335is 2D Coupe, Automatic DCT
Section 2545 (Double Clutch Gearbox - Repair - F12)
2011 BMW 335is 2D Coupe, Automatic DCTSECTION Section 2545 (Double Clutch Gearbox - Repair - F12)
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
- Double Clutch Gearbox (DKG)
- 28 00... Checking/topping up oil level in twin-clutch gearbox (GS7D36SG)
- 28 00 101 Installing replacement transmission (GS7D36SG)
- 28 50 001 Manual emergency release of transmission lock (GS7D36SG) S63
- 28 00 020 Removing and installing or replacing transmission oil sump (GS7D36SG)
- 28 10 050 Removing and installing parking lock module
- 28 00 001 Removing and installing twin-clutch gearbox (GS7D36SG) S63
- 28 00 060 Replacing output flange shaft seal (GS7D36SG)
- 28 10 550 Replacing parking lock module
- 28 60 000 Replacing pressure filter (GS7D36SG)
- 28 10 000 Replacing suction filter (GS7D36SG)
- Housing With Add-On Parts
- Double Clutch
- Control Unit, Mechatronics, Hydraulics
- 28 60... Notes on mechatronics (GS7D36SG)
- 28 60 010 Removing and installing mechatronics (GS7D36SG)
- 28 60 030 Removing and installing/replacing the hydraulic cap (GS7D36SG)
- 28 60 025 Replacing O-ring for wiring harness (GS7D36SG)
- 28 60 514 Replacing mechatronics (GS7D36SG)
- 28 60 000 Replacing pressure filter (GS7D36SG)
- 28 60 020 Replacing wiring harness (GS7D36SG)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.