Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011335I 4D SEDAN, STANDARDLABOR TIMESOTHER VARIANTDRIVELINES AND AXLESDIFFERENTIALS AND DRIVE AXLES - REARAXLE SHAFT ASSEMBLY (COMPLETE)REMOVE & INSTALL OR REMOVE & REPLACE
2011 BMW 335i 4D Sedan, Standard
Remove & Install or Remove & Replace
2011 BMW 335i 4D Sedan, StandardSECTION Remove & Install or Remove & Replace
WARNING: This page is about the 335i 2D Convertible, Automatic, which is a different variant/trim than selected.
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both | 3.6 | B | ||
| One Side | 2.8 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: | ||||
| Both Sides,All Four | 1.0 | B | ||
| One Axle,Both | 0.6 | B | ||
| One Axle,One | 0.4 | B | ||
| Combination Procedure: AXLE SHAFT JOINT: Remove & Replace: | ||||
| Both Sides,All Four | 1.4 | B | ||
| One Axle,Both | 0.7 | B | ||
| One Axle,One | 0.5 | B | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.