Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
11 28 010 Replacing drive belt for alternator (N54, N54T)
Special tools required:
Depending on the build date (version), the idler pulleys can be fitted with and without grooves.
Necessary preliminary tasks:
- Remove FAN COWL
Unfasten hose clamp (1).
Release snap fastener (3) 90° on boost pressure pipe in direction of arrow.
Pull off air hose (2).
Installation note:
Bring lock (3) back 90° into installation position.
Recirculated air hose must audibly snap into place.
Unclip line (1) from holder (2) in direction of arrow.
Release coolant hose (1) from bracket (2).
Release screw (1).
Fold air duct (2) down.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.