Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011135I 2D CONVERTIBLE, AUTOMATIC DCTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2962 (BRAKES - TIGHTENING TORQUES - F32)SLIP CONTROL SYSTEM (DSC)34 51 SLIP CONTROL SYSTEM (DSC)
2011 BMW 135i 2D Convertible, Automatic DCT
34 51 Slip control system (DSC)
2011 BMW 135i 2D Convertible, Automatic DCTSECTION 34 51 Slip control system (DSC)
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2016 BMW 435i xDrive, 2016 BMW 435i, 2016 BMW 428i xDrive, 2016 BMW 428i, and 2015 BMW 435i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - SLIP CONTROL SYSTEM (DSC)
| Type | Thread | Tightening specifications | Value | ||
|---|---|---|---|---|---|
| 1AZ | Control unit on hydraulic unit | F20/F21/F22/F30/F31/F32/F33/F34/F35 | Replace screws | 2 Nm | |
| DSC MK 100 | F22/F23/F30/F31/F32/F33/F34/F35/F36 | Replace screws | 5.5 Nm | ||
| 2AZ | ICM control unit on holder | F20/F21/F22/F23/F30/F31/F32/F33/F34/F35/F36 | 8 Nm | ||
| 3AZ | Pulse generator to swivel bearing/wheel carrier | F20/F21/F22/F23/F30/F31/F32/F33/F34/F35/F36 | 8 Nm | ||
| 4AZ | Bracket to hydraulic unit | F20/F21/F22/F23/F30/F31/F32/F33/F34/F35/F36 | 8 Nm | ||
| 5AZ | Bracket, hydraulic unit to body | F20/F21/F22/F23/F30/F31/F32/F33/F34/F35/F36 | 8 Nm | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.